https://turingpi.com logo
#│firmware-dev
Title
# │firmware-dev
t

terarex

12/03/2023, 5:00 PM
In v1.0.x BMC firmware, the fp:reset (HDD) and fp:sys (Power) LEDs were used respectively to distinguish BMC and node state/actions. In v1.1.0 and v2.0.x BMC firmware the fp:sys LED is being used for both functions. I don't much care which LED is used, but I'd like to see their status functions separated again. This way, someone can determine the general status of a TPiv2 cluster by glancing at the front panel LEDs, rather than looking at the board LEDs, which is not practical when using a rack mount case.